PLs. note that the wearable should house an electronics part (26x45x5 mm). Therefore it should be build-up of 2 parts (top/bottom), preferable with only 1 small screw to close it.

Thank you that clarifies a lot.

Do you also want to see what the inside would look like in photo presentations?

Sam.

You mean for marketing? That might be nice, but would require modelling of the electronics. But the wearable itself should not be transparent or anything

No, I mean do you want to see what the Stl model will look like if the two parts are seperated?

if you could upload an example pertaining to what you are looking for that would be great.

For inspiration: [Non image link removed]and [Non image link removed]and [Non image link removed](second blue pebble).

Hope this helps.

if you could some example pertaining to what you are looking for that would be great to get a general idea

your link has been removed. we cant see what your examples are.

Pls. see inspirational pictures I just uploaded

Thank you for attaching examples, just one last question about the hole for its use as a hanger. how it would be used as a hanger with a hole