Product image improvement - Surfboard

Hier ist was ein Geschäft in Australia für sein vector design vorgenommen hatte.

We are surfboards distributor based in Australia. We are planning to open up an online store as aother channel to promote our surfboard.

We have brief pictures for a range of our surfboards, which you need to use them and do few modifications by following instructions below. So we can put them on our website.

1. We would like to add our logo on to surfboard. Please refer to file "Logo on board" for approximate Location of the logo on the surfboard. The Logo should be at top centre of the board. Width of the logo should be less than 1/2 width of the board. This apply to both front and back of board. Logo file attached.

2.Refer to file "Effect01", improved picture should have front, side and back view of the board on the same picture.

3. Pattern on the front of the board: all boards need to have black pin stripe around the edge of the board as file "BoardPattern01" Only Product72 to have the 2 vertical pin stripe, which need to cut the edge of logo… Mehr lesen